Here is the scenario
When snmp read/write credentials validation runs on prime-server for router_ipaddress (destination router), router_ipaddress generates via syslog message like this:
router_ipaddress cw-prime-ipaddress NNNN: MM DD hh:mm:ss.nnn: %SYS-5-CONFIG_I: Configured from cw-prime-ipaddress by snmp
What configuration in router-ipaddress activities performs cisco prime-server?
The configuarion remains on server when validation finishes?
There is a reference of SNMP SET command in admin guide, but not clear detail about what command is executed in router_ipaddress and causes this trap notification message.
Those messages generates confusion to security network guys.
Regards