Cisco Prime Infrastructure disk IOPS issue

[helencloostermans]

Hello,

I know we should have migrated by now, but we still have 2 physical GEN 2 Prime appliances with Prime 3.10 (primary + secondary).

A couple of days ago the High Availability broke between the Primary and Failover appliances. After doing the Readiness Check for HA, it seems that I’m unable to re-establish the HA connection because the disks IOPS is too low on the primary appliance.

Does anyone of you have some tips on how I could solve this issue?

Thanks,

Helen

[Mark Elsen]

   - @helencloostermans    You are probably at a dead end here ; perhaps you could reboot the primary appliance 
                                          and try again. If that doesn't help and because of the GEN2's no longer supported ; 
                                          I would advice to migrate the Prime installation to a VM (with or without HA)

  M.