Cisco Prime Infrastructure disk IOPS issue

[helencloostermans]

Hello,

I know we should have migrated by now, but we still have 2 physical GEN 2 Prime appliances with Prime 3.10 (primary + secondary).

A couple of days ago the High Availability broke between the Primary and Failover appliances. After doing the Readiness Check for HA, it seems that I’m unable to re-establish the HA connection because the disks IOPS is too low on the primary appliance.

Does anyone of you have some tips on how I could solve this issue?

Thanks,

Helen

[Mark Elsen]

   - @helencloostermans    You are probably at a dead end here ; perhaps you could reboot the primary appliance 
                                          and try again. If that doesn't help and because of the GEN2's no longer supported ; 
                                          I would advice to migrate the Prime installation to a VM (with or without HA)

  M.

[helencloostermans]

@Mark Elsen 

Hi, I already tried an appliance and CIMC reboot, but unfortunately that didn't help. On the CIMC, all Storage tabs are green and seem ok, but disk IOPS is still too low.

I suppose I'll have to migrate to a VM...

Thanks,

Helen

[Mark Elsen]

  - @helencloostermans      Probably the best thing to do indeed. If the issue is related to fragmentation and or prolonged
                                          system usage then a complete re-install could possibly help. But because of  the Gen 2
                                                                            it's not worth the effort.

  M.