Dear all
I have a problem to see the events in the Cisco Prime, for example when an event occurs (port-shutdown) in the switch I receive this information:
Event Source | DFM |
Description | Cisco Command Monitoring -> Event Command Source: Command Line, Event Config Source: Running, Event Config Destination: Command Source |
Event Category | Other |
Fault Last Updated At | 07-Mar-2013 16:57:40 |
Event_Description | InformAlarm |
Component | 192.168.10.5: Cisco Configuration Management Trap |
I don't see the details of the port that was done, or other deatiled that give aditional information abut the event. I have configured the Cisco Prime in this way:
- Admin > Network > Notification and Action Settings > Event Sets : I have marked all the events
- Admin> Network > Notification and Action Settings>Fault - Email notification : My mail is configured , I received alarms by mail.
- Admin> Network > Notification and Action Settings>Fault Notification Group : is configured
| Notification Group Name: | TestSW4 |
| Device List: | 192.168.10.7 ; 192.168.10.6 ; 192.168.10.5 ; 192.168.10.253 ; |
| Event Set: | All |
| Event Severity: | Critical ; Warning ; Informational ; |
| Event Status: | Active ; |
| Customer Identification: |
|
The snmp was configured in the devices:
snmp-server system-shutdown
snmp-server enable traps
snmp-server community <community> RW
snmp-server host 192.168.10.x <community>
PLease your support or give some information to configure correctly the events and failures in cisco prime in order to see correctly
