I have a simple template to specify logging servers for routers. When I push it out, it fails on saving the config to NVRAM. (I tried with and without the "exit" in the configuration with the same results.) Oddly, I can embedded "wr mem" into the template and it works. I'm running build 3.1.0.0.132.
Any ideas?
configlet:
no logging host 10.31.14.5
logging host 10.31.14.6
logging host 10.31.14.11
no logging host 10.31.23.254 transport udp port 1514
exit
response:
terminal width 0
config t
no logging host 10.31.14.5
logging host 10.31.14.6
logging host 10.31.14.11
no logging host 10.31.23.254 transport udp port 1514
exit
rtr-p10r-gw-01#config t
Enter configuration commands, one per line. End with CNTL/Z.
rtr-p10r-gw-01(config)#no logging host 10.31.14.5
Host 10.31.14.5 not found for logging
rtr-p10r-gw-01(config)#logging host 10.31.14.6
rtr-p10r-gw-01(config)#logging host 10.31.14.11
rtr-p10r-gw-01(config)#no logging host 10.31.23.254 transport udp port 1514
Host 10.31.23.254 not found for logging
rtr-p10r-gw-01(config)#exit
rtr-p10r-gw-01#]]>
Error occurred while copying the Running config to startup config.