What is the maximum number of jobs that can run simultaneously..? We have a compliance template which reports that 1,381 devices are non-compliant, but it takes a little over one minute to make the changes on each device. This would work out to be over 20 hours and we only have a six hour maintenance window.
There is no limit to the number of simultaneous jrm jobs that can run. However, when it comes to Config Archive operations, you have to go through ConfigMgmtServer, so thread count will come into play. That will be your gating factor.
Assuming a multi-processor server with at least 4 GB of RAM, you can use the RME performance tuning tool to bump up thread counts. This can be done by running:
A compliance check/deploy job of 301 devices started at 23:42 and finished at 4:54 the next morning, so I guess we will need to do some tuning... ;o) Thank you for the tip about the tuning program, I shall certainly look at that.
Do you use Cisco DNA Center? Have you used and are you willing to provide your feedback in using the Cisco DNA Center help and documentation?
If so, we’d like you to complete the survey linked below. Your feedback will help provide more effective and easi...
Listen: https://smarturl.it/CCRS9E18Follow us: https://twitter.com/CiscoChampion Reaching the height of your career is no simple feat. It often requires a combination of pursuing the right education, building the right professional network and being ...
In a typical production SD-WAN deployment, we would probably have many remote sites connected via many different Internet connections to a centralized data center or a regional hub. In most regions in the world, Internet providers will always use some typ...