Curious message during activation of snmp traps in cisco router 2800
I activated snmp traps in cisco router 2800 (I didn't specify a set of them, so all of them were activated). The thing is, when i configure "snmp-server enable traps", appears a message in the next line :
" %Cannot enable both sham-link state-change interface traps.
%New sham link interface trap not enabled "
Anyway, traps are activated and are completely functional.
I would like to know, why this message appears... and also what is the difference between informs and traps, because I can activate both of the in a router to be sent to the network admin pc.
“Use Serviceability Features to Troubleshoot your Cat9K as a Cisco TAC Engineer”
This special event is open only to Cisco Customers and Partners.
Many pages in the Cisco Community are accessible only to Cisco customers, partners, or logged in ...
Cisco Champion Radio · S7|E40 From SD-WAN to SASE: Speed Up and Secure SaaS Internet Apps
The changing global environment has transformed how enterprise users connect to applications. The SASE architecture delivers important networking and securit...
Hi guys,Have a question regarding spanning tree and way its supposed to work when there is a redundant path in fiber daisy-chained switches. Root switch for all vlans is connected via fiber link to the first of the daisy-chained switches. Below is same co...
Hi Experts, I am designing a Ring topology to connect all all DRs and back to CR sites. Do I need to consider what is the maximum DRs which I am able to connect in the Ring and I am thinking does the latency will be affected if more sites will j...
HiI have an issue with a pppoe command in a subinterface. I'm using a c1841-advipservicesk9-mz.124-25f.bin IOSand I have a problem with the command pppoe-client dial-pool-number6. I can configure in a interface but I can't in a subinterface. Any...