cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
580
Views
0
Helpful
3
Replies

Energywise on switch

sprocket10
Explorer
Explorer

We are looking at the energywise commands on our switches to power off some ports over night. We have successfully powered off some ports, however if we want to make changes to say the times then it seems that we have to edit each port individually. Is there a way that you can configure say a group that ports belong to for energywise and link to a single time range?

1 Accepted Solution

Accepted Solutions

Sandeep Choudhary
VIP Mentor VIP Mentor
VIP Mentor

Hi,

Please follow these threads;

Https://supportforums.cisco.com/thread/164684

Https://supportforums.cisco.com/thread/2104246

Hope it helps

Regards
Don't forget to rate helpful posts

Sent from Cisco Technical Support iPhone App

View solution in original post

3 Replies 3

Sandeep Choudhary
VIP Mentor VIP Mentor
VIP Mentor

Hi,

Please follow these threads;

Https://supportforums.cisco.com/thread/164684

Https://supportforums.cisco.com/thread/2104246

Hope it helps

Regards
Don't forget to rate helpful posts

Sent from Cisco Technical Support iPhone App

Glad that you found your solution.

Regards

Sent from Cisco Technical Support iPhone App

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers