Hello,
I have a Cisco 6509 (running: WS-C6509 Software, Version NmpSW: 8.2(2)) and I want to set up etherchanneling on two ports located on our 10/100/1000 blade:
(enable) show mod 2
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
2 2 48 10/100/1000BaseT Ethernet WS-X6148-GE-TX no ok
.. I am hopeing someone can verify the steps to do this as what i've done doesn't seem to improve thruput any:
set port lacp-channel 2/3-4 573
set port lacp-channel 2/3-4 mode on
(enable) show lacp-channel group 573
Admin Port Channel LACP Port Ch Partner Oper Partner
key Mode Priority id Sys ID Port
----- ------ ------- --------- ---- ----------------------------- -------
573 2/3 on 128 1699 0:00-00-00-00-00-00 0
573 2/4 on 128 1699 0:00-00-00-00-00-00 0
If someone can confirm/correct what i've done, I'd greatly appreciate it.
Thanks!
