Firepower 1010 cannot access web GUI

dbronco · ‎09-04-2024

I am having some trouble with a new Firepower 1010 that was delivered with 7.2.5 running on it. I was having a few problems with a port not passing traffic when set to auto-negotiate, but we defaulted the device as a troubleshooting step and can now no longer access the web GUI.

I've followed this https://community.cisco.com.mcas-gov.us/t5/network-management/can-t-connect-to-web-configuration-for-firepower-1010/td-p/5055589 without success.

I ran through the running-config and the only noticeable difference I can see is 'http server enable' missing - as seen from a known good device. I've searched multiple sites and cannot figure out how to enable that, or if that is truly the problem. I've attached a screenshot of the error we're seeing and the CLI output.

Thank you for the help

marce1000 · ‎09-05-2024

- Could you add those directives from 'working appliance.txt' too in the running configuration of the
problematic firepower device(?)

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

MHM Cisco World · ‎09-05-2024

Manage the device locally? (yes/no) [yes]: Yes

did you select device mgmt locally ?
MHM