Firepower 1010 cannot access web GUI

[dbronco]

I am having some trouble with a new Firepower 1010 that was delivered with 7.2.5 running on it. I was having a few problems with a port not passing traffic when set to auto-negotiate, but we defaulted the device as a troubleshooting step and can now no longer access the web GUI. 

I've followed this https://community.cisco.com.mcas-gov.us/t5/network-management/can-t-connect-to-web-configuration-for-firepower-1010/td-p/5055589 without success. 

I ran through the running-config and the only noticeable difference I can see is 'http server enable' missing - as seen from a known good device. I've searched multiple sites and cannot figure out how to enable that, or if that is truly the problem. I've attached a screenshot of the error we're seeing and the CLI output. 

Thank you for the help

[marce1000]

  - Could you add those directives from 'working appliance.txt' too in the running configuration of the
  problematic firepower device(?)

 M.

[dbronco]

I did try that but they don't seem to be valid commands. I haven't been able to question mark my way through it yet, do you know how to do this? 

[MHM Cisco World]

Manage the device locally? (yes/no) [yes]: Yes 

did you select device mgmt locally ?
MHM 

[dbronco]

Yep, I followed your directions from another post to make sure everything was set correctly. 

[Gopinath_Pigili]

Hello dbronco,

Please follow the link..you can find similar kind of discussion....

https://community.cisco.com/t5/network-management/can-t-connect-to-web-configuration-for-firepower-1010/td-p/5055589

Best regards
******* If This Helps, Please Rate *******