Full "show run" output on Cisco Prime Infrastructure

[adir.nosrat]

Hi,

does anyone know if there's a way to see the entire "show run" config in one file?

on the gui it is presenting the configuration is divided into sections like - interfaces, ACL's, SNMP and so on...

i'm looking for one full file that i will be able to copy and paste on another device without deleting every headline.

hopefully you understand my request.

thanks,

Adir

[Marvin Rhoads]

Your GUI should have a tab in the device's configuration section (in Device Work center) for "raw" output vs. formatted.

[Marvin Rhoads · Accepted solution]

Add - it's under the configuration archive tab:

[adir.nosrat]

thanks, thats exactly what i was looking for!