cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
970
Views
0
Helpful
2
Replies

help required in configuring telnet

sivakondalarao
Beginner
Beginner

Hi,

We have two PIX 515E firewalls working in HA mode.

I wanted to configure telnet access to firewalls from outside interface.

PIX version is 6.3(5)

I kept PC outside to outside interfaces.

PIX outside IP is 10.10.200.3, inside IP is 10.10.202.5 corresponding virtual IPs are 10.10.200.2 and 10.10.202.7

I have tried following configurations:

pix(config)#telnet 0 0 inside

pix(config)#telnet 0 0 outside

pix(config)#telnet 10.10.200.0 255.255.255.0 outside

pix(config)#telnet 10.10.202.0 255.255.255.0 inside

pix(config)#telnet 10.10.200.200 255.255.255.255 outside

I am able to telnet from internal interface side using inside ip address.

But from outside test pc with IP 10.10.200.200 I am not able to telnet to PIX.

I enabled logging console 5.

when I tried to telnet to outside virtual IP it is not showing any traffic to firewall.

If I try to outside interface I am able to see the traffic like

packets received from source 10.10.200.200 to 10.10.200.3

any help in this configuration. I wanted to telnet firewall from test pc.

Regards

SKRAO

1 Accepted Solution

Accepted Solutions

sravan_235
Beginner
Beginner

from outside u have to give ssh access

View solution in original post

2 Replies 2

sravan_235
Beginner
Beginner

from outside u have to give ssh access

tahseen12
Beginner
Beginner

Either using SSH or IPSEC.

You can't telnet to outside interface without using above due to security

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers