Folks, I need to paste this config/templace on switches. When there is no cry key gen rsa already in place in the switch, the command works accordingly. If there is a key already in place, then I get prompted for "yes/no" and then I need to enter "800" to select the length I want.
Question: is there any way to force the command below to input "YES" and "800" when I get such prompt?
(...)
!-This one works well if no cry key is in place.
cry key generate rsa
[pick 800] ssh_rsa_verify: RSA modulus too small: 512 < minimum 768 bits
(...)
!- As you can see, if pasted onto a switch which already has the key it hangs there waiting for a command prompt input.
myswitch(config)#cry key generate rsa
% You already have RSA keys defined named domain.c
% Do you really want to replace them? [yes/no]: yes
Choose the size of the key modulus in the range of 360 to 2048 for your
General Purpose Keys. Choosing a key modulus greater than 512 may take
a few minutes.
How many bits in the modulus [512]: 800
(...)
