if(X)Table counters not be populated

[net.curious]

Dear Cisco Community

We recently upgraded our routers (ASR1001-X) with the very latest IOS-XE (Amsterdam) and Rommon versions.

Router seems stable so far, but we are facing an issue with the monitoring.

We monitor our Devices with Observium, and we notice that nont of the subinterfaces shows any traffic on graphs.
I have contact observium and they said that

"if we don’t show traffic for it, it’s almost certainly because the device isn’t populating the if(X)Table counters for it, and you probably need to talk to Cisco."

Do, any of you guys, faced any kind of this issue?
Can anyone help me?

Thanks a lot!!|

#sh ver
Cisco IOS XE Software, Version 17.03.03
Cisco IOS Software [Amsterdam], ASR1000 Software (X86_64_LINUX_IOSD-UNIVERSALK9_NOLI-M), Version 17.3.3, RELEASE SOFTWARE (fc7)

ROM: 17.3(1r)
System image file is "bootflash:asr1001x-universalk9_noli.17.03.03.SPA.bin"

[marce1000]

 - You may need to verify the used-snmp-oids again for the particular interface in the snmp manager software. Sometime they get changed after an upgrade , verify with a manual-snmpwalk on the device (ifName).

 M.

[net.curious]

Hello!!

That was quick Marce1000

I will try to manual snmpwalk using the OID that Observium is using for getting that Data.

Thanks