Hi,
I have been following the steps in this document (Cisco IOS XR Programmability Configuration Guide for ASR 9000 Series Router - Using Data Models [Cisco ASR 9000 Series Aggregation Services Routers] - Cisco)
I copied and pasted configuration I pushed to the router below:
Option 1: ssh into the router with netconf session
When I ssh into the router from linux, I get the error message below:
#ssh root@10.10.10.10 -s netconf
FIPS mode initialized
ssh: connect to host 10.10.10.10 port 22: No route to host
Option 2: run netconf after ssh session is established
I then tried to run netconf after I ssh into the router, I copied and pasted hello xml and pasted:
Hello xml message I copied and pasted after netconf prompt on the router:
What am I doing wrong?
Thanks.
