cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
810
Views
0
Helpful
1
Replies
Highlighted
Beginner

LMS 4.1 -- SwitchPort Summary Report -- Wrong total/connected Port-Count

Hi all,

we discovered a problem with accuracy of SwitchPort Summary Reports im LMS 4.1.

The amount of shown Total and connected ports in reports is greater than displayed on Device-CLI.

Has anybody else discoverd same problems with these reports? Any suggestions?

Thanks -- Lothar

------

Follwoing output is a Cat4500 with 12.2(46)SG

(1) Ports counted on Device-CLI = 56

SWITCH1>sh mod

Mod Ports Card Type                             Model             Serial No.

1    2 Supervisor IV 1000BaseX (GBIC)         WS-X4515

2    6 1000BaseX (GBIC)                       WS-X4306-GB

3   24 10/100/1000BaseT (RJ45)                WS-X4424-GB-RJ45

4    6 1000BaseX (GBIC)                       WS-X4306-GB

5   18 1000BaseX (GBIC)                       WS-X4418-GB

(2) Ports given by SwitchPort-Report = 60

/opt/CSCOpx/campus/bin/ut -cli -switchPortSummary -devices SWITCH1

Device Name,IP Address,Connected Ports,Free Ports,Free Down Ports,Total Ports

SWITCH1,10.192.209.47,50,3,7,60

(3) Several Ports a duplicate in Connected Ports Details

Port   Port Name                         Oper Status      Admin Status

Gi1/1   XXXX2001_G1/13                   UP               UP

Gi1/1   XXXX2001_G1/13                   UP               UP

Gi1/2   XXXSW153_G0/13, xxxxxxxxxxxxx    UP               UP

Gi1/2   XXXSW153_G0/13, xxxxxxxxxxxxx    UP               UP

Gi2/1   XXXSW30_G0/1, xxxxxxxxxxxxxxxx   UP               UP

Gi2/1   XXXSW30_G0/1, xxxxxxxxxxxxxxxx   UP               UP

1 REPLY 1
Highlighted
Beginner

Hi lo.mueller,

I'm facing the same problem in LMS 4.2.1, appreciate if you can share how to fix it.

Thanks.

Faizul

Content for Community-Ad