LMS3.1 psu problem - Consistency check failed for base package

[Mohammed Tolib]

Hi all,

I tried to install the following packges for CiscoView 6.1.9:

Rtr2900.cv50.v2-0.zip

Rtr3900.cv50.v2-0.zip

but it gives me the following error:

Consistency check failed for base package NGMARShare

There are no Packages to be installed.

I uninstalled all packages and installed them again after I copied these two packages in the packages sources folder but it failed again.

Any one can help?

Thanks

[Fadi Twal]

the error message is telling you that you need the following dependent package in order to install the ones you have

NGMARShare.cv50.v1-11.zip or later.

so try to install this one and then see how it goes.

the NGMARShare it self may need a dependent package also so you need to read the packages info files in order to know what else you need.

if you face any issue please share the output of

-psuci -p cvw -q -all

-the package you are trying to install.

-the error message you hit.

[Mohammed Tolib]

Thanks a lot Fadi,

NGMARShare.cv50.v1-18.zip has sucessfully installed. After that the two packages

Rtr2900.cv50.v2-0.zip and Rtr3900.cv50.v5-0.zip have been sucessfully installed also.

But when I tried to istall the package Cat3750.cv50.v13-0.zip it gives me the error

"Consistency check failed for base package DtShare"

although this NGMARShare is the latest version. So what is next?

Attached the output of -psuci -p cvw -q -all

Thanks in advance

[Fadi Twal · Accepted solution]

the new package you try to install depends on a package that you don't have

DEPENDENT PACKAGE
=================
DtShare V1.5 (DtShare.cv50.v1-5.zip)

this can be seen from the error message you got

"Consistency check failed for base package DtShare"

my advice is to read the "Release Information" for the packages you try to install

you can find the Release Information in the same page of the download.

hope this helps,

also it's better to update all the device packages if your server have internet connectivity from CS > Software Center > device update.

[Mohammed Tolib]

Thanks again Fadi.

I sucessfully installed DtShare.cv50.v1-8.zip and NGMARShare.cv50.v1-18.zip. After that I installed three new device packages for CiscoView:

Cat3750.cv50.v13-0.zip, Rtr2900.cv50.v2-0.zip, Rtr3900.cv50.v5-0.zip and everything seem fine.

And yes it is mentioned in the readme file what base package should be installed first but I did not read it carefully.