cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1673
Views
0
Helpful
3
Replies

Netflow on WS-C4500X-16 with PRTG

Simon1337
Level 1
Level 1

Hello

How can I find out if netflow is supported? It is needed in conjunction with PRTG.

Model: cisco WS-C4500X-16 (MPC8572) processor (revision 9)
Firmware: IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSALK9-M), Version 03.08.04.E RELEASE SOFTWARE (fc2)

PRTG: NETFLOW V5 & NETFLOW V9

Many thanks

3 Replies 3

Mark Malone
VIP Alumni
VIP Alumni
Hi
yes its supported heres output from my 45x switches in VSS running 3.8.7 running ipbase

#flow ?
exporter Define a Flow Exporter
loc-rate Set Loss Of Confidence shaping rate
monitor Define a Flow Monitor
record Define a Flow Record

xxxxxxxxxxxx(config)#do sh ver | i 03
Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSALK9-M), Version 03.08.07.E RELEASE SOFTWARE (fc2)
System image file is "bootflash:cat4500e-universalk9.SPA.03.08.07.E.152-4.E7.bin"

Thank you very much for your reply. I also have this information. According to cisco the version "Flexible NetFlow" is supported. But what about Netflow V5 & Netflow V9 ?

 

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/15-1-2/XE_340/configuration/guide/config/fnf.html

no thats whats supported above only , the other versions are not available once flex is there

(config)#ip f?
finger forward-protocol ftp

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: