cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
647
Views
0
Helpful
1
Replies

New CWLMS 4 install on Solaris 10

ChauseBlong
Level 1
Level 1

Good day,

I have just started with a new installation on a Solaris 10 server

As soon as i run the ./setup it stops with the following message:

DHCP not enabled on this machine

The install then exits.

I am using a vpn connection to the server, could this be the cause?

Thanks

1 Accepted Solution

Accepted Solutions

AFROJ AHMAD
Cisco Employee
Cisco Employee
Hi,

Check if you are Installation LMS 4.0 on a supported Platform, here is the supported  list of OS:
LMS 4.0 supports the following Solaris 10 releases: *Solaris 10, 10/09 release *Solaris 10, 05/09 release *Solaris 10, 10/08 release *Solaris 10, 05/08 release *Solaris 10, 08/07 release *Solaris 10, 11/06 release

Thanks

Afroj

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****

View solution in original post

1 Reply 1

AFROJ AHMAD
Cisco Employee
Cisco Employee
Hi,

Check if you are Installation LMS 4.0 on a supported Platform, here is the supported  list of OS:
LMS 4.0 supports the following Solaris 10 releases: *Solaris 10, 10/09 release *Solaris 10, 05/09 release *Solaris 10, 10/08 release *Solaris 10, 05/08 release *Solaris 10, 08/07 release *Solaris 10, 11/06 release

Thanks

Afroj

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****

Review Cisco Networking for a $25 gift card