prime infrastructure 2.1 deploy config task

[pawelkostera]

Hi,

I'm struggling with the cisco prime infrastructure 2.1 again :]

When i create a configuration task (it could be anything like an access list etc.) and deploy that to a switch or group of switches it does not work.

In the Job Dashboards i just see that the job has failed, and there is no details on what would be the reason, just "No data available".

This was working before, and all snmp/cli credentials are up to date, and all devices are sync.

Any suggestion on what could that be ?

Pawel

[Ashok Kumar]

Hi,

Please create a simple CLI template e.g "snmp-sever community ASHOK RW" as per below navigation:-

Design > Configuration > Feature Design > Templates > CLI Templates > CLI > Save as a New Template

Now, Deploy the same as per below navigation 

Configuration Deployment > Configuration Tasks > Templates > My Templates 

if still job fails, we need to collect the debug logs 

- Ashok

***************************************************************************************************************

Please rate the post or mark as correct answer as it will help others looking for similar information

**************************************************************************************************************

[pawelkostera]

Hi Ashok,

This fails with the "No data available" error as every other job;

Where can i configure and collect the debug logs ?

Pawel

[pawelkostera]

Great support for the great cisco software  -

cisco really sucks at developing management software :[

PK