cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1085
Views
0
Helpful
3
Replies

RME 4.0 Baseline Templates

scbne
Level 1
Level 1

Hi all,

Is there a way to make a template to check if there are any devices with extra entries, our problem is that when we run a compliance check it only checks for what we have on the template but if there is an extra entry on a device it still shows the device as compliant, is there a way to make a template so that it shows if a device has extra entries such as the access-list's or can Baseline Templates only check for the minimum requirments.

3 Replies 3

wdrootz
Level 4
Level 4

compliance check will check if the baseline configuration is configured in the device, you may try compare configuration option to find the extra entries.

frode
Level 1
Level 1

Hi,

long time since this question came up. Have anyone a solution to get this to work.

my problem is:

want to verify that my devices have this config:

ip access-list standard remote-access

permit 1.1.1.1

permit 2.2.2.2

line vty 0 15

access-class remote-access in

I have created a compliance check that is checking for these entries, but also want to verify there is no other entries in the access-list (like "permit 3.3.3.3")

-frode

Make sure your template has the Ordered feature enabled, and it should catch additional ACEs in your ACL.

Review Cisco Networking for a $25 gift card