Hello I'm updating the software on about 200 3750 stacks. During the verification process I'm used to get a warning with the messages swim1132,1201 and 1106. But jobs run then successfully.
But sometimes the verification step fails with the SWIM1200 error. That is a litte strange because all the switches have the same flash size of 15998976 bytes.
The error messages are in the attachment.
I woult be very happy, if somebody can give me an advice.
This is CSCsu49349. The bug is fixed in RME 4.3. The workaround is to go to RME > Software Mgmt > Software Repository, then click on the name of the image. Reduce its required flash size down one setting (i.e. make the requirement 8 MB). This will allow the image to deploy properly.
Please support CSC Helps Haiti
Thanks for the tip but ....
I tried to change the "minimum flash value" in der sw repository. But it doesn't work. If I change the value,click ok and then click again on the name of the image then I see still the old value. I do that with admin rights.