cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1496
Views
0
Helpful
1
Replies

Threshold Violation Error

roycemathew
Level 1
Level 1

hi All,

 

I am getting an error as below on a 3750V2 connecting to a 6509 WS-X6724-SFP port. I am getting Input errors on interface at 3750v2 side.

3750V2# sh logg

Apr 14 09:42:57: %SFF8472-5-THRESHOLD_VIOLATION: Gi1/0/1: Rx power low warning; Operating value: -17.6 dBm, Threshold value: -17.0 dBm

Input Error O/p is as below;

3750v2#sh int gi1/0/1 | in CRC --> connects to first core switch
     7130 input errors, 153 CRC, 0 frame, 0 overrun, 0 ignored
3750v2#sh int gi2/0/1 | in CRC --> connects to second core switch
     18418 input errors, 611 CRC, 0 frame, 0 overrun, 0 ignored

Please let me know if this error or alert is a cause of concern.

 

 

 

 

 

 

 

 

1 Reply 1

AFROJ AHMAD
Cisco Employee
Cisco Employee

Hi ,

 

This could be because of ::

Avago SR erroneously reports THRESHOLD_VIOLATION
CSCsz81516
 
If you are concern about the errors, you might need to open a TAC case to get the faulty module replaced.
 
Thanks-
Afroz
***Ratings Encourages Contributors ****
Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco