Hi
a few days ago i was asked to do a show tech to give to a support company, but the command never completed.
now i can no longer configure my switch by terminal, and i cannot terminate the user sessions.
i have followed all advices i could find for the issues :
https://www.cisco.com/c/en/us/support/docs/ios-nx-os-software/ios-software-releases-124-mainline/46942-nvram.html
SW-4500X-01#sh conf
Using 0 out of 524284 bytes, uncompressed size = 19502 bytes
%Error opening nvram:/startup-config (Device or resource busy)
SW-4500X-01#show user
Line User Host(s) Idle Location
1 vty 0 admin idle 3d22h oxf-6l9qjz1.repinbv.com
2 vty 1 admin idle 3d22h remote.repinbv.com
3 vty 2 admin idle 3d22h oxf-6l9qjz1.repinbv.com
4 vty 3 admin idle 2d15h remote.repinbv.com
* 5 vty 4 admin idle 00:00:00 oxf-6l9qjz1.repinbv.com
Interface User Mode Idle Peer Address
SW-4500X-01#clear line 1
[confirm]
[OK]
SW-4500X-01#clear line 2
[confirm]
[OK]
SW-4500X-01#clear line 3
[confirm]
[OK]
SW-4500X-01#clear line 4
[confirm]
[OK]
SW-4500X-01#show user
Line User Host(s) Idle Location
1 vty 0 admin idle 3d22h oxf-6l9qjz1.repinbv.com
2 vty 1 admin idle 3d22h remote.repinbv.com
3 vty 2 admin idle 3d22h oxf-6l9qjz1.repinbv.com
4 vty 3 admin idle 2d15h remote.repinbv.com
* 5 vty 4 admin idle 00:00:00 oxf-6l9qjz1.repinbv.com
disconnect ssh vty x doesn't do anything either.
how can i terminate the user sessions or the processes that hog the files ?
