04-18-2008 10:53 AM
can I able to see on user tracking the duplex and the speed , vtp information. or the state of of the device. any way to configure ?
Thanks
Solved! Go to Solution.
04-18-2008 11:11 AM
When viewing a UT report, if you select the All Columns layout instead of the default Standard layout, you will get columns for duplex mode, port speed, and the VTP domain associated with that entry. Device state is not shown. The device had to have been up at the time the UT entry was last seen.
You can also create custom layouts showing only the columns you want to see. That can be done under User Tracking > Reports > Custom Layouts.
04-18-2008 11:11 AM
When viewing a UT report, if you select the All Columns layout instead of the default Standard layout, you will get columns for duplex mode, port speed, and the VTP domain associated with that entry. Device state is not shown. The device had to have been up at the time the UT entry was last seen.
You can also create custom layouts showing only the columns you want to see. That can be done under User Tracking > Reports > Custom Layouts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide