06-19-2007 10:08 PM
Are backups of a WLSE device supported in LMS 2.6? I know WLSE's have their own built-in TFTP/SCP configured backups but would like to manage this via LMS.
I've noticed that I can managed WLSE devices in CiscoWorks LMS 2.6. I have been able to add two WLSE devices (a 1030 and 1133) but am having trouble getting RME to back up the device configuration. The error I receive is that a config archive failed - check device credentials.
I have entered the correct credentials, and a device credential check verifies the SNMP read and Telnet work. However the SNMP read/write comes back with not supported, and the Enable by Telnet does not try.
Solved! Go to Solution.
06-19-2007 10:53 PM
WLSE config collection is supported with RME 4.0.5. RME requires that the WLSE be running 2.13 or later for config fetch to work. It will use a mix of telnet or SSH plus either HTTP or HTTPS to fetch the config. Therefore, you need to enter both primary credentials AND HTTP/HTTPS credentials for your WLSE devices.
06-19-2007 10:53 PM
WLSE config collection is supported with RME 4.0.5. RME requires that the WLSE be running 2.13 or later for config fetch to work. It will use a mix of telnet or SSH plus either HTTP or HTTPS to fetch the config. Therefore, you need to enter both primary credentials AND HTTP/HTTPS credentials for your WLSE devices.
06-20-2007 05:14 PM
Thanks again!
It was the HTTP settings that I had to enable. Also I had to make sure HTTP was enabled as part of the Transport settings under Config Management.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide