Solved: MX Cellular active uplink

Fabian11 · ‎05-24-2024

Hi everyone,

I can't find the api call to set the cellular active uplink to enable on Meraki MX.

Is that hidden somewhere?

Thank you

aleabrahao · ‎05-24-2024

Ther is no API for it.

You just can get the uplink settings.

https://developer.cisco.com/meraki/api-v1/api-reference-early-access-api-products-appliance-configure-uplinks-settings-get-device-appliance-uplinks-settings/

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

View solution in original post

aleabrahao · ‎05-24-2024

Ther is no API for it.

You just can get the uplink settings.

https://developer.cisco.com/meraki/api-v1/api-reference-early-access-api-products-appliance-configure-uplinks-settings-get-device-appliance-uplinks-settings/

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Fabian11 · ‎05-24-2024

That is very unfortunate, hopefully this will be added in future