2 6509's and 2 PIX's Failover Help...

[cyberlinx2000]

Ok here is my question.

6509A firewall Mod:

3 Contexts:Admin Context2 Context3

6509B firewall Mod:Nothing configed...

I have 2 6509s and each one of them have a Firewall Module. I have one of the firewall modules confgured. Now I want to replicate it over using Failover. How would I go about doing this?

[rais]

I assume you already have a 802.1Q trunk between the two 6509s and you have plenty of available bandwith between them.

You need to have regular config + a failover VLAN on primay. On secondary, all you need is failover interface + its IP.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_module_configuration_guide_chapter09186a00802010c0.html#wp1128821

Thanks.