01-18-2007 02:13 AM - edited 03-11-2019 02:21 AM
Hi all
I am getting the following error
415014: Maximum of 10 unanswered HTTP requests exceeded
on an ASA
do you know what parameters I can change so the maximum unswered is more than 10.
Cheers
Arni
Solved! Go to Solution.
01-18-2007 03:46 AM
Hi,
This syslog message is generated in ASA,when the "http-map strict-http" command is configured and a more than unanswered 10 HTTP requests have been seen on a single connection.
Have look the following URL for the explanation.
It appears that you cannot alter the number of attempts( 10), however you can configure the firwall to not drop the connection, if it exceeds 10 unanswered http requests.
Here's the URL from the command manual to alter the behavior of this command.
Hope this helps. Kindly rate the post if it was helpful.
-VJ
01-18-2007 03:46 AM
Hi,
This syslog message is generated in ASA,when the "http-map strict-http" command is configured and a more than unanswered 10 HTTP requests have been seen on a single connection.
Have look the following URL for the explanation.
It appears that you cannot alter the number of attempts( 10), however you can configure the firwall to not drop the connection, if it exceeds 10 unanswered http requests.
Here's the URL from the command manual to alter the behavior of this command.
Hope this helps. Kindly rate the post if it was helpful.
-VJ
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide