05-02-2003 07:47 AM - edited 02-20-2020 10:43 PM
Hey,
I tried to install 6.3 on my pix515e from version 6.2.1 and it just killed it. It repeatedly failed over about every minute and had no access from inside out on one of the interfaces. when it was up for the minute, my outside in rules worked fine but still no one on interface 2 could get out. I also installed the latest version of the pdm. Luckily I just pushed it ack to 6.2.1 and it is back to normal. Any thoughts from anyone.
Thanks
Jim Kiddoo
05-05-2003 08:44 AM
My install of 6.3(1) worked okay, but when I tried to use PDM 2.0(2), it said it needed a new image. When I tried a new PDM 2.1(1), it STILL says I need a new image. Do you have any experience with that?
Mike
05-05-2003 09:05 AM
you have to install the 3.0 pdm which is in beta. You can get it off the cisco software
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide