- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-20-2021 09:46 AM
Hi
So hope ive been getting this right if i want to block traffic to and from the same addresses I creat a rule it would be as the below
source ANY destination ANY source networks 23.33.44.55 destination networks 22.33.44.55 Source ports Any Dest ports ANY
and block with reset
??
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-20-2021 11:06 AM
Hi @benolyndav sure if you've an explict or implict deny rule at the bottom of the ACP from outside to inside, then yes it would not be needed.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-20-2021 09:52 AM
@benolyndav You'd need 2 rules, 1 from "any" to 22.33.44.55 block with reset and another from 22.33.44.55 to "any" block with reset.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-20-2021 11:01 AM
Hi Rob
Thanks
Traffic the other way would be blocked anyway unless explicitly allowed from Outside to inside so is the 2nd rule even needed?
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-20-2021 11:06 AM
Hi @benolyndav sure if you've an explict or implict deny rule at the bottom of the ACP from outside to inside, then yes it would not be needed.
