01-20-2007 01:39 AM - edited 03-11-2019 02:22 AM
Hi
This is my topology
VPN Client (192.168.20.0/24)
|
|
PIX
|
| (10.50.0.0/16)
Layer 3 Switch
-------------------------|
| |10.30.0.0
|(10.20.0.0/16) |/16
ATM Router
| (Natted)
| 172.16.29.0
| /24)
Branch Off
router
| 10.4.4.0/24
| 10.10.0.0/8
I can conneted to the 10.20.0.0/16 network I need to allow 10.4.4.0 and 10.10.0.0 networks to my VPN Clients.
Please help I have tried putting all the routes every where but still cannot connect.
my config is attached
01-20-2007 03:41 AM
Simple as pie.
Add the follwing lines:
access-list 102 permit ip 10.10.0.0 255.255.0.0 192.168.20.0 255.255.255.0
access-list 102 permit ip 10.4.0.0 255.255.0.0 192.168.20.0 255.255.255.0
This will extend the NAT 0 to the desired subnets.
Please rate if this helped.
Regards,
Daniel
01-29-2007 01:04 AM
thanx ..it was of great help . I just missed it and had to add the new subnet for the nat list on my branch office router and it worked.
thanx once again
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide