I'm trying to understand why the keyword "default" in the ACL is needed.
Ext Access List configuration commands:
<1-2147483647> Sequence Number
default Set a command to its defaults
deny Specify packets to reject
permit Specify packets to forward
R3(config-ext-nacl)#default permit icmp any any
R3(config-ext-nacl)#do sh access-l
Extended IP access list log-test-1
10 permit ospf any any (1201 matches)
ip access-list extended log-test-1
permit ospf any any
In the output of the command "show access-list" and in the output of the config (show running-config) it is not displayed. Please, tell me why it is needed and how to apply it.
Thank you very much for your reply, but unfortunately, it has not helped much. Tried to repeat what you said - did not work. Will not it make it difficult for you to show a listing or pseudo-listing of step-by-step usage so i can see how to apply it?
Site to Site IPSec VPN with Dynamic IP Endpoint is typically used when we have a branch sites which obtains a dynamic public IP from the Internet ISP. For example an ADSL connection.One important note is that Site-to-Site VPN with Dynamic remote routers P...
On R1, configure a key ring that defines the peer R3:Address: 188.8.131.52Local and remote pre-shared key: cisco R1(config)#crypto ikev2 keyring KRR1(config-ikev2-keyring)# peer R3R1(config-ikev2-keyring-peer)# address 184.108.40.206R1(config-ikev2-keyring-pee...
This document shows how to use the Port Radius NAS PORT Id Attribute in a compound condition to control access with 802.1X.A user jdoe is allowed to access the network only through the physical port FastEthernet 0/1 of the switch and the user jwhite is al...
This document provides a configuration example of Security Assertion Markup Language (SAML) Authentication on FTD managed over FDM. The configuration allows Anyconnect users to establish a VPN session authenticating with a SAML Identity Serv...
DMVPN Dual Hub Dual Cloud Pros and ConsProsNo single point of failureQuick failover if routing protocols are tunedLoad balancing is easyTraffic engineering is easyEasy to work with multiple ISPsConsNeed 2 tunnels per spokeConfiguration is more complicated...