Active Standby ASA with downlink switches in VRRP

[aseemchhab]

Hi All,

I am looking for help in getting a concrete topology for a couple of ASAs which will be configured in active standby mode. The ASAs will be connected to 2 switches which are already running VRRP.

Will the following topology help?

http://www.cisco.com/c/dam/en/us/td/i/200001-300000/250001-260000/255001-256000/255098.eps/_jcr_content/renditions/255098.jpg

If the above will, how can I configure the 2 ports on the 2 different switches in a port channel?

Help will be highly appreciated. Thanks in advance!

Regards,

Aseem

[Karsten Iwen]

The mentioned topology can work and is quite common. But the two switches that connect the ASAs must be one logical switch. That can be a VSS-pair or a switch-stack depending on the devices you use.