02-19-2013 08:04 AM - edited 03-11-2019 06:02 PM
Hi everyone,
I need to add ACL to Active ASA by ASDM.
At bottom of ASA it shows Failover status -- this device is currently in Active status.
Need to know if i add ACL to this ASA will it syn with other ASA also?
Thanks
Mahesh
Solved! Go to Solution.
02-19-2013 01:20 PM
Hi,
Around 99% of the configurations should always be done on the Active ASA unit. They will automatically replicate to the Secondary Unit.
So yes, when you configure ACL changes on the Active ASA unit they will be added/changed on the Standby unit also
On the CLI side atleas the ASA warns if you are mistakenly configuring the Standby Unit.
- Jouni
02-19-2013 01:20 PM
Hi,
Around 99% of the configurations should always be done on the Active ASA unit. They will automatically replicate to the Secondary Unit.
So yes, when you configure ACL changes on the Active ASA unit they will be added/changed on the Standby unit also
On the CLI side atleas the ASA warns if you are mistakenly configuring the Standby Unit.
- Jouni
02-19-2013 10:39 PM
Hi Jouni,
Many thanks for confirming my thoughts
regards
mahesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide