After the power failure, Cisco ASA5506-X Threat Defense can't connect to FMC.

[npitschugin]

Hi,

after the power failure, Cisco ASA5506-X Threat Defense (6.2.3.7) can't connect to FMC (6.2.3.7).

The output of "show managers" command on FTD is "No managers configured"

> show managers
No managers configured.

Is there possibility to re regiser FTD to FMC?

[Sheraz.Salim]

That strange.

if you see this

> show managers
No managers configured.

mean in order to get this to communicate with FMC you have to configure it again. first thing first delete your 5506-X from FMC. than go to FTD command line and give command

> configure manager add 192.168.1.1 Cisco123

[npitschugin]

Hi Sheraz,



thank you for your reponse.



I have the error after giving the command : configure manager add 192.168.1.1 Cisco123



getPeersByRole: unable to connect to db at /usr/local/sf/lib/perl/5.10.1/SF/Peer Manager/Peers.pm line 226.

Unable to access DetectionEngine::bulkLoad



Regards,



Nikolay

[kapydan88]

configure manager add 192.168.1.1 Cisco123

in this particular case 192.168.1.1 - ip address of your FMC. You need use your FMC address

                                  Cisco123 - password for adding a device. Must be the same on the your ASA-5506X and FMC side.

[kapydan88]

You need to check this ASA-5506X in FMC and delete it from it. Then add asa again.

[Sheraz.Salim]

@kapydan88 on the spot. yes 192.168.1.1 will be your FMC address in FTD cli.

[npitschugin]

Hi,

i have the error in FTD:

> configure manager add 192.168.2.246 cisco123
getPeersByRole: unable to connect to db at /usr/local/sf/lib/perl/5.10.1/SF/PeerManager/Peers.pm line 226.
Unable to access DetectionEngine::bulkLoad

[kapydan88]

https://community.cisco.com/t5/network-security/link-firepower-with-firesight/td-p/2805182

try this way - this topic deals with a similar problem.

[CSCO12674262]

HI PLEASE I HAVE THE SAME PROBLEME 

getPeersByRole: unable to connect to db at /ngfw/usr/local/sf/lib/perl/5.10.1/SF/PeerManager/Peers.pm line 226.
Unable to access DetectionEngine::bulkLoad

THANK YOU FOR HELP