cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2230
Views
0
Helpful
6
Replies

allow all show command for an user

Dear all,

I need to create an user that can have the permission to do all show command on my device. I have an ASA IOS 9.2.

 

I already see some other guide but all guide explain how permit single show command.

 

What can do to gain this ?

 

Thank you,


Daniele.

6 Replies 6

Abheesh Kumar
VIP Alumni
VIP Alumni
do you have any aaa-server configured..???
If you have a tacacs server you can do the show command filter with that, or you need to allow privilege 15 to that particular user.

no I am using local authentication

privilege 15 is required to execute show run command, If allow privilege 15 that user can able to go to config mode as well.

 

HTH

Abheesh 

I need that the user can run all show command but can't go in configure terminal mode

the ASA does NOT support views.as you dont have AAA you can not achieve this

 

Although if you want to restrict access to the device then you can use AAA

please do not forget to rate.

Integrate with a tacas server to achieve this.

HTH
Abheesh
Review Cisco Networking for a $25 gift card