ASA 5505 - Additional DHCP scope - Clients can't reach internet

[RGISupport]

Good afternoon,

Firewall:

Cisco ASA 5505

v 8.2(5)

Security Plus License

Switch (not important):

Netgear FS726TP

Firmware Version 2.0.1_09

The goal:

• Add two additional VLAN's
• Each with their own DHCP scopes
• The VLAN's separate from each other
• Clients able to get out to the internet

Current Result:

First - to omit the switch, I tried plugging a laptop into the ASA port that I configured and got the same result. 

On the client connected to the VLAN I configured, I get the proper IP address and can ping the default gateway for this interface - but cannot go out to the internet.

Let me know what else you need from me?

Thanks!

Andrew

[Marvin Rhoads · Accepted solution]

Did you create a NAT rue for the new subnets?

Your running configuration would help.

[RGISupport]

I did not - I'm kind of new at configuring security appliances.  The config is attached.

[Marvin Rhoads · Accepted solution]

Try adding:

nat (vlan201) 1 0.0.0.0 0.0.0.0
nat (vlan250) 1 0.0.0.0 0.0.0.0

[RGISupport]

That did it, thank you so much Marvin!

Andrew