Network Security

HI experts, i have a consideration creating a some load balance through ASA using NAT features. but i am getting stuck in one place.                                                                          (outside1) WAN1   ---------         ------ V...

Hi,Scenario: Mail Server in the Inside NetworkMail server IP Add: 10.34.1.10 and Nat IP: 201.1.1.5Configured Access list and objectnetwork.object network obj-10.34.1.10  host 10.34.1.10object-group service tcp_lotusnotesgrp tcp port-object eq www por...

Hi,I cant seem to png from dmz to outside - i get the following outputnat (dmz,outside) source dynamic any interface timeout pat-xlate 0:00:3012asa01# packet-tracer input dmz icmp 192.168.0.10 1 1 4.2.2.2 detailedPhase: 1Type: ROUTE-LOOKUPSubtype: Re...

I am looking to buy a couple of asa5512-dc-k8 to run in active/failover mode. Does anyone know why you cant but a DC box with K9 encryption? It just doesnt make any sense to me. Couldnt I just load K9 software on it? thanks!

Hello all, Do the Cisco ASA 5512x support native failover to 1 of 2 WAN ports? For instance, if I have ISP A configured on one WAN and ISP B configured on the other can I program the ASA the automatically recognize if one link on a WAN port goes down...

Hello, I have very old ASDM and the ver:6.1. Also content filtering Trend micro also was configured. Recently, I noticed Trend Micro is removed from ASA. I tried to configure again and it is not accepting the license which had given buy cisco.Now my ...

I have a 5520 with a current span session configured. My question is, can I create a new session, using the same source ports, but a different destination port? I need to make sure this won't disrupt traffic spanning on the initial session.Session 3-...

Support Community,Ok, so recently we started to see a spike in tcp & udp traffic with the source and destination ports as 0.  I did a little research and found this article from PC World,http://www.pcworld.com/article/2061080/spike-in-traffic-with-tc...

What version of ASDM can be used with ASA5505 Cisco Adaptive Security Appliance Software Version 8.2(1).

Hello, I'm trying to figure out if there's a way to configure the web interface for Cisco ACS and Cisco Prime Infrastructure to use x.509 smart card authentication. I know I can run this into an F5 to authenticate and pass credentials, but I want to ...

Hi Guys, I have an ASA primarly used for guest-wireless access, I have applied rate-limiting as shown in the below table, but this morning I notice interface utilization hit 320-Mbps, I was under the impression, it should not allow above and beyond 1...