ASA 5505 not allowing connection
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-07-2023 07:26 AM
I have a ASA that when I turn on a firewall rule I can not get to the destination I want to get to. I can get to the webpage, but it just spins and does not time out.
However, when I turn off the firewall rule and allow all ip addresses to come through on the same computer I can get into the account I want.
The question: Why would I be able to get to the website and get into it with the firewall rules off, but not when the firewall rules are on?
Could it be an authentication issue or an IP address issue?
- Labels:
-
Cisco Cafe
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-07-2023 07:41 AM
Hi @Tbone
To answer that we need to see the rule you are applying on the firewall.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-08-2023 12:37 AM
first try check DNS by lookup
then use packet tracer to see which FW make issue exactly
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-10-2023 02:40 PM
My first thought is, is there redirection happening?
Other than that we will need to see the ASAs configuration along with information on source and destination IPs.
Please remember to select a correct answer and rate helpful posts
