07-25-2017 02:24 AM - edited 03-12-2019 02:44 AM
Hi,
I'm configure my ASA 5505 firewall.
I configure inside like 192.168.0.1 since our pcs are all with ip 192.168.0.X and outside 192.168.1.112 since our router is 192.168.1.1.
I'm able to ping 8.8.8.8 (google) but from my pc I'm not able to reach internet. On my pc I have ip 192.168.0.6 subnet mask 255.255.255.0 and default gateway 192.168.0.1.
Can you help me?
Solved! Go to Solution.
07-25-2017 06:10 AM
Hi,
If you are assigning IP addresses through ASA then you can add DNS on it.
If not then the DHCP server assigning IP's should push a DNS server to the
Regards,
Aditya
Please rate helpful and mark correct answers
07-25-2017 02:33 AM
pls post your running configuration.
Regards,
Safwan
07-25-2017 02:47 AM
Hi Muhammed,
this are my configurations
!
interface Ethernet0/0
switchport access vlan 2
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
!
interface Ethernet0/5
!
interface Ethernet0/6
!
interface Ethernet0/7
!
interface Vlan1
nameif inside
security-level 100
ip address 192.168.0.1 255.255.255.0
!
interface Vlan2
nameif outside
security-level 0
ip address 192.168.1.112 255.255.255.0
!
ftp mode passive
object network obj_any
subnet 0.0.0.0 0.0.0.0
pager lines 24
logging asdm informational
mtu inside 1500
mtu outside 1500
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
no arp permit-nonconnected
!
object network obj_any
nat (inside,outside) dynamic interface
route outside 0.0.0.0 0.0.0.0 192.168.1.1 1
timeout xlate 3:00:00
timeout pat-xlate 0:00:30
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
user-identity default-domain LOCAL
aaa authentication telnet console LOCAL
http server enable
http 192.168.0.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart warmstart
crypto ipsec security-association pmtu-aging infinite
crypto ca trustpoint _SmartCallHome_ServerCA
no validation-usage
crl configure
crypto ca trustpoint ASDM_Launcher_Access_TrustPoint_0
enrollment self
fqdn none
subject-name CN=192.168.0.1,CN=ciscoasa
keypair ASDM_LAUNCHER
crl configure
crypto ca trustpoint ASDM_Launcher_Access_TrustPoint_1
enrollment self
fqdn none
subject-name CN=192.168.0.1,CN=ciscoasa
keypair ASDM_LAUNCHER
crl configure
telnet 192.168.0.0 255.255.255.0 inside
telnet timeout 5
no ssh stricthostkeycheck
ssh timeout 5
ssh key-exchange group dh-group1-sha1
console timeout 0
dhcpd auto_config outside
!
dhcpd address 192.168.0.5-192.168.0.36 inside
dhcpd enable inside
!
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
ssl trust-point ASDM_Launcher_Access_TrustPoint_1 inside vpnlb-ip
ssl trust-point ASDM_Launcher_Access_TrustPoint_1 inside
username cisco password 3USUcOPFUiMCO4Jk encrypted
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum client auto
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
inspect ip-options
!
service-policy global_policy global
prompt hostname context
call-home reporting anonymous
07-25-2017 02:59 AM
As you are testing the reachability to internet with ping , you have to allow the ping on outside interface with below command.
access-list acl-outside extended permit icmp any any
access-group acl-outside in interface outside
Regards,
Safwan
07-25-2017 03:06 AM
From my pc I'm able to ping 8.8.8.8 but not ping www.google.com
07-25-2017 02:34 AM
Hi,
Please use the command:
fixup protocol
Regards,
Aditya
Please rate helpful and mark correct answers
07-25-2017 02:47 AM
Hi Aditya,
what does the command do?
07-25-2017 03:09 AM
Hi,
This would enable
https://supportforums.cisco.com/discussion/11124056/why-enable-icmp-inspection-will-allow-icmp-traffic-pass-asa
Regards,
Aditya
Please rate helpful and mark correct answers
07-25-2017 03:09 AM
The result of the command is: converting 'fixup protocol icmp ' to MPF commands and change anything
07-25-2017 03:19 AM
Hi,
Please check your DNS settings on PC.
Manually add a DNS server and then test.
Regards,
Aditya
Please rate helpful and mark correct answers
07-25-2017 03:23 AM
Adding DNS on my pc, internet works ok. Is there any way to put DNS inside the firewall? We have many pcs and it would be hard to do.
07-25-2017 06:10 AM
Hi,
If you are assigning IP addresses through ASA then you can add DNS on it.
If not then the DHCP server assigning IP's should push a DNS server to the
Regards,
Aditya
Please rate helpful and mark correct answers
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide