02-27-2017 05:09 AM - edited 03-12-2019 01:59 AM
Is there a way to restore the factory settings for the ASA 5506 Firepower ?
I messed up the configuration and had to do a password recovery. So I followed this guide:
https://supportforums.cisco.com/document/79016/asa-password-recovery
But now it dosen't run there is no light in the Ethernet ports and I cannot get in contact with the web interface.
The mangement interface works fine.
Please help a newbee
Thanks
Anders
Solved! Go to Solution.
02-27-2017 05:26 AM
You are talking about the base ASA and not the FirePOWER module itself? Then:
ASA(config)# config factory-default
02-27-2017 05:26 AM
You are talking about the base ASA and not the FirePOWER module itself? Then:
ASA(config)# config factory-default
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide