ASA 5506 Firepower Reboot command

[azbarcode]

Seems the pattern matching on the reboot command only check the first few characters...

"ciscoasa# session sfr
Opening command session with module sfr.
Connected to module sfr. Escape character sequence is 'CTRL-^X'.

(none) login: admin
Password:
Last login: Thu Oct 15 16:24:24 GMT+7 2015 on pts/0

Copyright 2004-2015, Cisco and/or its affiliates. All rights reserved.
Cisco is a registered trademark of Cisco Systems, Inc.
All other trademarks are property of their respective owners.

Cisco Linux OS v5.4.1 (build 12)
Cisco ASA5506 v5.4.1 (build 211)

>
> system reboot
This command will reboot the system.  Continue?
Please enter 'YES' or 'NO': yah

Invalid input
This command will reboot the system.  Continue?
Please enter 'YES' or 'NO': yesterday

Broadcast message from root@(none) (Thu Oct 15 16:35:34 2015):

The system is going down for reboot NOW!
> Remote card closed command session. Press any key to continue.
Command session with module sfr terminated.
"

[Andres Vega]

@azbarcode,

Actually the problem happens when YES word is in whatever phrase, it is now under investigation.

Here some outputs for your reference.

[azbarcode]

Worse too, it seems to look for 'yes' before 'no'

(none) login: admin
Password:
Last login: Thu Oct 15 16:38:02 GMT+7 2015 on pts/0

Copyright 2004-2015, Cisco and/or its affiliates. All rights reserved.
Cisco is a registered trademark of Cisco Systems, Inc.
All other trademarks are property of their respective owners.

Cisco Linux OS v5.4.1 (build 12)
Cisco ASA5506 v5.4.1 (build 211)

>
>
> system reboot
This command will reboot the system.  Continue?
Please enter 'YES' or 'NO': noyes

Broadcast message from root@(none) (Fri Oct 16 09:29:31 2015):

The system is going down for reboot NOW!
>