01-19-2018 01:30 AM - edited 02-21-2020 07:10 AM
Hey. I have problem with ASA config.
My network looks like this:
- WAN connected to the router (EdgeMax PRO) to eth0.
- router (eth1) connected to the server (DELL R410).
- in the router on eth1 I have configured the entire class /24 of IPs
Both the server and the router are configured with static IP (without DHCP).
I want to enable Cisco ASA 5506-X with FirePOWER Services between the router and the server.
Unfortunately, I have a problem with configuring the firewall.
How can I configure a firewall to support 256 static IPs?
Wiring looks like that:
![415359.jpg 415359.jpg](https://community.cisco.com/t5/image/serverpage/image-id/6523iAEF16D641E606E06/image-size/large?v=v2&px=999)
Solved! Go to Solution.
01-19-2018 05:02 AM
You could configure the ASA to run in transparent mode. It's like a L2-switch that also runs a firewall. If your goal is not to change the infrastructure but still protect the server, then this will be the easiest approach.
01-19-2018 04:46 AM
I dont understand what you mean by "the firewall to support 256 static IPs"?
01-19-2018 05:02 AM
You could configure the ASA to run in transparent mode. It's like a L2-switch that also runs a firewall. If your goal is not to change the infrastructure but still protect the server, then this will be the easiest approach.
01-19-2018 05:48 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide