ASA-5506X Transparent mode can't log in ASDM-IDM

[bizniz]

Hi, 

I set the ASA-5506X to Transparent mode.

It looks like working bcz ping to ASA-5506X OK.

However, I can't log into ASDM-IDM Launcher.

Any help would be appreciated.

[Rob Ingram]

@bizniz 

When you change from routed to transparent mode, the initial configuration is wiped. You will need to setup the ASA again, including IP address on a BVI or mgmt interface, default gateway/route, permitted ssh/http (for asdm access) source networks and username/password.

You've not provided enough information for us to help you. Please provide us with your configuration.

[bizniz]

Thanks Rob, 

here is what I did so far, 

ciscoasa(config)# interface GigabitEthernet1/6
ciscoasa(config-if)# nameif outside
ciscoasa(config-if)# no shut

ciscoasa(config)# interface GigabitEthernet1/7
ciscoasa(config-if)# nameif inside
ciscoasa(config-if)# no shut

ciscoasa(config-if)# int BVI 6
ciscoasa(config-if)# ip address 192.168.1.2 255.255.255.0

Gateway 192.168.1.1 / 255.255.255.0

ciscoasa(config-if)# show Bridge-Group 6
interfaces:
GigabitEthernet 1/6
GigabitEthernet 1/7

Management System IP Address:   192.168.1.20     255.255.255.0

Username: cisco Password: cisco12345

Could you please  give me a tip for permitted ssh/http (for asdm access) source networks?

Thanks again.

[Marius Gunnerud]

first thought is that you haven't added commands to allow access to the ASDM. 

asdm image <image name>

http server enable

http 0 0 <interface name> ! would be better if you change 0 0 to a more specific IP or subnet.

Other than that we would need more information as well as the full running configuration (remove any public IPs, usernames and passwords).