Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
524
Views
0
Helpful
4
Replies

ASA 5510 Not loading automatically the config when booting up

Not applicable

‎07-12-2017 12:42 PM - last edited on ‎03-12-2019 02:41 AM by

Hello,

I would like to find out why my ASA 5501 is not loading the saved config when booting up automatically? I have never seen that before on a Cisco device, I have to manually copy start run to reload it once is up. Thanks in advance. 

Labels:
0 Helpful
4 Replies 4

Aditya Ganjoo
Cisco Employee
Cisco Employee

‎07-12-2017 06:36 PM

Hi,

Can you share the output of show flash and show ver from the device?

Regards,

Aditya

0 Helpful

Not applicable
In response to Aditya Ganjoo

‎07-13-2017 07:28 AM

Thanks Aditya for your help, here is the info requested:

Preview file
5 KB
0 Helpful

Aditya Ganjoo
Cisco Employee
Cisco Employee
In response to

‎07-13-2017 08:04 AM

Hi,

Please change the config reg value to 0x01 using the command:

config-reg 0x01

Currently its 0x41 which is done to reset the password.

After changing the value write the memory and reload and you should be good.

Regards,

Aditya

Please rate helpful posts

0 Helpful

Not applicable
In response to Aditya Ganjoo

‎07-13-2017 10:53 AM

Awesome Aditya, I will try that. Thanks. 

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card