11-26-2015 02:04 AM - edited 03-11-2019 11:57 PM
Hello
We have 2 ASAs( 5512) configured in active standby mode. Ios version is 9.0.3 for bothe the ASAs.
We are trying to upgrade the IOS to 9.1.6 . First we upgraded the IOS to the version 9.1.3 at this point failover works properly.
When we try to upgrade standby firewall to 9.1.6 once rebooted it boots from the 9.1.6 but it cannot find the active mate.
What can be the issue as with all other earlier versions of IOS failover is working properly.
Thanks And Regards
Pushpak
11-26-2015 04:21 AM
Check failover config, If looks ok. Then may be bug, contact cisco tac.
11-26-2015 04:30 AM
Hi,
Try to ping the two ASAs over failover link IP addresses and ensure reachability is there between two firewalls on failover link.
If it is not connected directly then you can check the vlan configuration on switch.
Let us know if you still face the issue,
Thanks,
RS
11-29-2015 05:22 PM
Hi Rishabh,
When booted with ios version 9.1.3 ping works from bothe the ASAs. But when we upgrade it to 9.1.6 ping wont work. Both the ASAs are connected back to back and not through switch.
Faiover configuration is proper as it works with 9.1.3 unless there are some changes in version 9.1.3.
Thanks
Pushpak
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide