cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

2624
Views
0
Helpful
4
Replies
Spagsterj
Beginner

ASA 5515-x self power on

Is there a way through the CLI to have the ASA 5515-x power back on after a power failure? Currently, the only way to restore power is to press the power button. The X series does not have a power switch the same as the 5500 series.

Thanks in advance!

4 REPLIES 4
Julio Carvajal
Advisor

Hello,

No way to do it from the CLI,

Sorry to inform you that,

If you have any other question just let me know,

Regards,

Julio

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC

And is it possible to set automatic start after power failure by another way?

Regards

Vladimir

Hi,

I have just gotten my new ASA5515-X

While I remember these things being asked before, it seems to me that when I have my ASA powered on and cause a power outage, after a short period of time (1-2min) the ASA boots back on without touching the power button at all.

I have still to read anything about this but I would find it very very strange if a power outage at customer premises would require a user to manually boot the unit back on. Just doesnt seem that it could be done is such a bad way?

- Jouni

Actually,

Seems I checked this thing long time ago when I still didnt have any new X -model ASAs.

Information can be found here

http://www.cisco.com/en/US/docs/security/asa/hw/maintenance/5500xguide/asa_overview.html#wp1061571

Also the thread where I answered was this

https://supportforums.cisco.com/thread/2186476

Power button

A hard switch that turns the system on and off. Once depressed, the button stays in the "on" position:

•On—The power symbol on the button illuminates.

•Off—The power symbol on the button is dark.

For information about the power state, see the "Power Supply Considerations" section.

- Jouni

Content for Community-Ad