07-17-2015 06:50 PM - edited 03-11-2019 11:17 PM
Hello Folks,
Anyone know if memory of a flash on ASA 5520 completely dead should I see anything when I'm connecting to console port ?
(at least initial boot message?). I have a unit it looks ok but zero output via console. Tried all speed setting same issue.
I think it hardware issue and I need to fix it myself.
Kind Regards,
MB
Solved! Go to Solution.
07-17-2015 10:21 PM
Hi,
If the flash is corrupted on the ASA device , you should see some prompt on the Console.
I think if no console , you should proceed with the RMA of the unit through TAC.
Thanks and Regards,
Vibhor Amrodia
07-17-2015 07:01 PM
Hi,
What is the status of the LED when you power the unit.
Check this link:
http://www.cisco.com/c/en/us/td/docs/security/asa/hw/maintenance/guide/asa_hw/overview.html
You may want to try reseating Memory in the unit,
Thx
MS
07-17-2015 10:21 PM
Hi,
If the flash is corrupted on the ASA device , you should see some prompt on the Console.
I think if no console , you should proceed with the RMA of the unit through TAC.
Thanks and Regards,
Vibhor Amrodia
07-17-2015 11:28 PM
I can't do RMA since it old unit for the lab. The logic board looks ok so it kind strange.
What about memory if all memory dead should I see something via console ?
The status LED yellow and the rest green.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide